0
Article Tier 2 Sign in to save

The wastewater with high microplastics concentrations: characteristics of microplastics and removal methods

AI summary Read the abstract

This review summarizes existing research on microplastics in wastewater from laundry, plastic recycling, landfill leachate, and treatment plant sludge, finding sludge is the largest source. It reports that physical and chemical methods like membranes, filtration, and coagulation remove microplastics effectively, while standard biological treatment methods do not.

Study Type Environmental

ABSTRACT (i) Four main wastewater sources of high microplastics concentration, including laundry wastewater, wastewater from plastic recycling processes, leachate from landfills and sludge from wastewater treatment plants. (ii) Four main microplastics types, including polyethylene, polypropylene, polystyrene, and polyester. (iii) Four main shapes, including fibers, fragments, films, and pellets. (iv) Six main physicochemical processes, including membrane, filtration, flotation, flocculation-coagulation, adsorption and advanced oxidation-photodegradation. (v) Three main biological processes, including microalgae, bacteria, and marine organisms. Microplastics (MPs) pollution from wastewater presents a global challenge, causing detrimental impacts on human health and ecosystems. This review initially focuses on the occurrence and distribution of MPs, their potential negative impacts, and characteristics of four main wastewater sources (namely wastewaters from laundry, plastic recycling processing, landfill leachate, and wastewater treatment plant sludge). This review then critically analyzes existing technologies for MPs removal, their efficiency, feasibility, and limitations. For MPs sources, sewage sludge is identified as the largest source of MPs waste entering the environment. Recent studies show that MPs could be removed effectively by physicochemical methods (coagulation, adsorption, filtration, flotation, advanced oxidation, and membrane filtration) under suitable environmental conditions. However, MPs are not removed effectively by the conventional biological method in wastewater treatment facilities. Membranes can achieve very high removal efficiency for all MP sizes, especially when combined with other treatment methods. The performance of flotation and sand filtration, conversely, is highly dependent on MP sizes. The main challenges of flotation and flocculation/adsorption are the operation's complexity and residual management, respectively. This review proposes recommendations to enhance the effectiveness of MPs removal methods and emphasizes the need for standardized MPs sampling and analysis protocols.

More Papers Like This

Article Tier 2

Microplastics removal through water treatment plants: Its feasibility, efficiency, future prospects and enhancement by proper waste management

AI summary Read the abstract

Researchers reviewed over 80 studies on water treatment plant performance and found microplastic removal ranges widely — from 16% in basic primary treatment up to near 100% with advanced membrane systems — but a major flaw is that removed microplastics concentrate in sludge, which can re-enter the environment. The review recommends optimizing coagulants and sludge treatment to prevent microplastics from simply being relocated rather than eliminated.

Article Tier 2

Microplastics in wastewater treatment plants: Sources, properties, removal efficiency, removal mechanisms, and interactions with pollutants

AI summary Read the abstract

This review examines microplastic sources, properties, removal efficiency, and removal mechanisms across different wastewater treatment plant stages. Researchers found that while treatment plants remove a significant portion of microplastics, they cannot eliminate them entirely, resulting in the continued release of millions of particles into the environment daily through effluent and sludge.

Article Tier 2

Understanding microplastic presence in different wastewater treatment processes: Removal efficiency and source identification

AI summary Read the abstract

Researchers tracked microplastic removal across different treatment stages at two wastewater treatment plants and found overall removal rates of 90% and 97%. They discovered that population density in the served area was a bigger driver of influent microplastic levels than sewage volume, and that activated sludge served as the primary trap for captured particles. The study identified laundry washing and daily consumer products as the main sources of microplastics entering the treatment plants.

Article Tier 2

Recent advances on microplastics pollution and removal from wastewater systems: A critical review

AI summary Read the abstract

This review summarizes the latest research on microplastic detection, occurrence, and removal in wastewater treatment plants. While treatment plants can remove 57-99% of microplastics depending on the stage, significant amounts still escape into the environment through treated water and sludge. The findings highlight the need for advanced treatment methods to prevent microplastics from reaching waterways and ultimately human water supplies.

Article Tier 2

Microplastic contamination in wastewater: Sources, distribution, detection and remediation through physical and chemical-biological methods

AI summary Read the abstract

This review covers how microplastics end up in wastewater from sources like textile fibers, personal care microbeads, and broken-down plastic debris, and how they often survive the treatment process. Current removal methods like filtration and chemical degradation are costly and not fully effective. The lack of standardized ways to measure microplastics in wastewater makes it difficult to assess the full scope of human exposure through water systems.

Research digests by email

When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.

Email me about

Share this paper