We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Microplastic polymer accumulation, distribution, and toxicity in sediment of a freshwater tidal marsh, USA
AI summary Read the abstract
Researchers examined microplastic distribution and polymer composition in sediment cores from a freshwater tidal marsh in Pennsylvania, identifying over 4,500 microplastic particles across 29 polymer types. Polypropylene, polyurethane, and tire rubber were the most abundant polymers found. The study assessed toxicity risks of six common polymers and provides new data on microplastic contamination in an understudied freshwater wetland environment.
Microplastics (MPs) persistence in the environment leads to exposure to both wildlife and humans, which is a concern globally. However, understanding MP sources, transport pathways, and environmental risks from exposure remains limited in many environments. Identifying polymer types provides crucial information to address this knowledge gap. This study examines MP distribution and polymer composition in sediment from the John Heinz National Wildlife Refuge at Tinicum, PA, USA, a freshwater tidal marsh. We identified 4590 MP particles and 29 polymer types using laser direct infrared spectroscopy across five sediment cores from four sampling sites. The most abundant polymers were polypropylene (PP), polyurethane (PU), and tire rubber. To evaluate toxicity, we focused on six common polymers produced internationally: polyethylene, PP, polyvinyl chloride, polyethylene terephthalate, PU, and polystyrene. MP concentrations, polymer diversity, and risks increased downstream based on the polymer hazard index and potential ecological risk index, indicating environmental danger. We observed higher MP concentrations and risks in recent depositional sediments. Interestingly, MP concentrations in sediment reported from estuaries located across five continents (18 countries) showed no significant differences, suggesting shared sources of contamination in global estuarine sediments. The global MP burial flux was estimated at approximately 0.2 Mt. yr. Our findings highlight that MPs primarily originate from polymers commonly used to produce single-use plastic products, emphasizing the need for stricter waste management and reduction efforts aimed at disposable plastics.
More Papers Like This
Occurrence and distribution of microplastics in wetlands
AI summary Read the abstract
This review examined the available research on microplastic occurrence and distribution across wetland ecosystems worldwide. Researchers found that wetlands are prone to microplastic pollution, with polyethylene and polypropylene being the most commonly detected polymer types, and fibers and fragments being the dominant particle shapes. The study highlights that wetlands remain understudied compared to other aquatic ecosystems despite their ecological importance as transitional zones.
Distribution characteristics and ecological risk assessment of microplastics in intertidal sediments near coastal water
AI summary Read the abstract
Researchers analyzed microplastic contamination in intertidal sediments from coastal areas and assessed the ecological risks these particles pose. They found microplastics in all sampled locations, with fibers and fragments being the most common shapes, and polyethylene and polypropylene the dominant plastic types. The study's risk assessment indicates that microplastic pollution in these transitional zones between land and sea warrants greater environmental attention.
Urban Microplastic Pollution Revealed by a Large-Scale Wetland Soil Survey
AI summary Read the abstract
Researchers conducted a large-scale survey of wetland soils across an urban area and found an average of 379 microplastic particles per kilogram, with abundance closely linked to proximity to the city's economic center. Polypropylene was the most common polymer type, and fiber and fragment shapes dominated the samples. The study found that atmospheric particle pollution and heavy metal concentrations in soil were strongly correlated with microplastic levels, suggesting shared urban pollution sources.
Impact of land cover on microplastics accumulation in freshwater sediments
AI summary Read the abstract
Researchers collected sediment cores from four Pennsylvania watersheds with different land uses to examine how land cover influences microplastic accumulation in freshwater sediments over time. Urban and agricultural watersheds showed higher microplastic concentrations than forested watersheds, with fibers being the most common morphotype.
Studying the Presence and Distribution of Microplastics in a Norfolk Salt Marsh
AI summary Read the abstract
Researchers investigated the presence and distribution of microplastics in a Norfolk salt marsh, examining whether fundamental sedimentation processes and dense vegetation make salt marshes significant long-term sinks for microplastic accumulation in coastal environments.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.