We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Fine grinding of thermoplastics by high speed friction grinding assisted by guar gum
AI summary Read the abstract
Researchers applied high-speed friction grinding with plant-based additives to break down thermoplastics including PLA, HDPE, and polypropylene into fine particles. This controlled grinding technique could be used to produce standardized microplastic reference materials for laboratory research on plastic pollution.
Abstract High speed friction grinding has been used to grind plant and food substances in water but never been explored for grinding of thermoplastics like polylactic acid (PLA), low and high density polyethylene and polypropylene. Such grinding was investigated in this work and was made possible by using 0.5% guar gum solution instead of just water because increasing the viscosity of water reduced their settling and the speed of passing through the grinder. Tensile, flexural, and impact strengths of the plastics were studied and higher grinding efficiency of PLA could be explained by its low elongation‐at‐break compared to low density polyethylene, high density polyethylene, and polypropylene. The microplastics (2000–45 μm) were studied for mass and particle size distributions and by scanning electron microscopy, 13 C CP/MAS NMR, Fourier transform infrared spectroscopy, differential scanning calorimetry, and thermogravimetric analysis. In addition, viscosity of guar gum and contact angles was measured. This new technology can produce finely ground microplastics (710–45 μm) for a variety of applications.
More Papers Like This
Exploring fragmentation techniques for the preparation of test microplastics
AI summary Read the abstract
To advance microplastic research, scientists need standardized test particles that mimic real-world plastic fragments, but producing these reliably is challenging. This study compared three cryogenic grinding techniques — mixer mill, immersion blender, and ultracentrifugal mill — for preparing laboratory microplastics, providing practical guidance for harmonizing methods across the research community.
Preparation of block copolymer-stabilised microspheres of common polymers and their use as microplastics proxies in degradation studies
AI summary Read the abstract
Researchers developed a simple method to produce standardized model microplastic particles made from common polymers for use in laboratory degradation studies. Reliable model microplastics are essential for consistent research into how different plastic types break down in the environment and affect living organisms.
Quality-by-design and current good practices for the production of test and reference materials for micro- and nano-plastic research
AI summary Read the abstract
Researchers outlined best practices for producing standardized reference materials used in micro- and nanoplastic research, covering both top-down fragmentation and bottom-up precipitation methods. They provided examples using common polymers like polyethylene, polypropylene, polystyrene, and PET across different size ranges. The study addresses a critical need in the field, since reliable reference materials are essential for validating the analytical methods used to detect and measure plastic pollution.
Mechanical formation of micro- and nano-plastic materials for environmental studies in agricultural ecosystems
AI summary Read the abstract
Researchers developed a mechanical method for producing micro- and nanoplastic particles from agricultural plastic films, creating materials more representative of real-world soil contaminants than the idealized spheres commonly used in lab studies. They successfully generated polydisperse fragments from low-density polyethylene mulch film using cryogenic milling. The study provides the research community with more realistic plastic materials for studying the environmental fate and ecological effects of agricultural plastic pollution.
Air‐based polyethylene fragmentation with high yield to form microplastic particles as reference material candidates
AI summary Read the abstract
Researchers developed an air-based machine to produce aged microplastic reference material particles with high yield, using ultraviolet aging of thin polyethylene foil followed by mechanical fragmentation with clean air, eliminating the need for resource-intensive liquid nitrogen grinding. Physical and chemical characterization confirmed the method produces particles between 1 and 1000 µm that mimic environmentally weathered microplastics, addressing a key gap in standard reference materials for microplastic research.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.