Temperature Dependence of the Deformation Behavior of High-entropy Alloys Co20cr20fe20mn20ni20, Co19cr20fe20mn20ni20с1 and Co17cr20fe20mn20ni20с3. Mechanical Properties and Temperature Dependence of Yield Strength

This paper discusses the temperature dependence of the mechanical properties of multicomponent alloys Co20Cr20Fe20Mn20Ni20 (Cantor alloy), Co19Cr20Fe20Mn20Ni20С1 and Co17Cr20Fe20Mn20Ni20С3 under uniaxial static tension in the temperature range from 77 to 473 K. It is shown that after thermomechanical treatment all the alloys have an fcc crystal structure, but unlike single-phase Co20Cr20Fe20Mn20Ni20 and Co19Cr20Fe20Mn20Ni20С1 alloys, the alloy with 3 at % carbon exhibits large incoherent chromium carbides. Alloying with carbon causes solid solution strengthening of the austenitic phase and dispersion hardening, and promotes grain refinement in the Cantor alloy. Solid solution strengthening contributes to an increase in the athermal and thermal stress components of σ0.2, leading to higher yield stress values and stronger temperature dependences σ0.2( T ) in Co19Cr20Fe20Mn20Ni20С1 and Co17Cr20Fe20Mn20Ni20С3 alloys than in the Cantor alloy. The results of X-ray diffraction and microscopic analysis indicate that despite the differences in the total concentration of interstitial atoms in Co19Cr20Fe20Mn20Ni20С1 and Co17Cr20Fe20Mn20Ni20С3 alloys, the concentrations of carbon dissolved in the crystal lattice of the austenite phase are close. However, the higher strength properties of Co17Cr20Fe20Mn20Ni20С3 compared to Co19Cr20Fe20Mn20Ni20С1 are determined primarily by grain boundary strengthening and, to a lesser extent, by dispersion hardening. Both factors such as lowering the deformation temperature and alloying with carbon contribute to an increase in the deforming stresses of the Cantor alloy. It is shown that alloying with carbon affects the staged plastic flow of the Cantor alloy: the tensile curves of Co19Cr20Fe20Mn20Ni20С1 carbon alloy exhibit a well-defined stage of microplastic deformation, and the flow curves of Co17Cr20Fe20Mn20Ni20С3 alloy at the initial stages of plastic flow have a parabolic shape, typical of the deformation of alloys with large incoherent particles. The elongation to failure of Co20Cr20Fe20Mn20Ni20 and Co19Cr20Fe20Mn20Ni20С1 alloys increases linearly with decreasing deformation temperature, i.e., the mechanical properties of single-phase alloys are improved in the region of low test temperatures. For Co17Cr20Fe20Mn20Ni20С3 alloy, an increase in strength properties during low-temperature deformation is accompanied by a decrease in ductile characteristics, and the alloy becomes brittle from the viewpoint of macromechanical behavior.