We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Identification of microplastic pathways within a typical European urban wastewater system
AI summary Read the abstract
Researchers used thermoextraction/desorption gas chromatography/mass spectrometry to trace microplastic pathways through a European urban wastewater system, identifying key sources and transfer points where microplastics enter and move through municipal treatment infrastructure.
Abstract In recent years, thermoextraction/desorption‐gas chromatography/mass spectrometry (TED‐GC/MS) has been developed as a rapid detection method for the determination of microplastics (MP) mass contents in numerous environmentally relevant matrices and, in particular, for the measurement of polymers in water samples without time‐consuming sample preparation. The TED‐GC/MS method was applied to investigate a typical European municipal wastewater system for possible MP masses. Such investigations are important in view of the recent revision of the Urban Wastewater Treatment Directive. Four different representative sampling sites were selected: greywater (domestic wastewater without toilet), combined sewer, and influent and effluent of a wastewater treatment plant (WWTP). All samples were collected by fractional filtration. Filtration was carried out over mesh sizes of 500, 100, 50, and in some cases, 5 µm. Polyethylene (PE), polypropylene (PP), and polystyrene (PS) were detected in all samples, with the PE fraction dominating in all cases. Styrene‐butadiene rubber which serves as an indication of tire abrasion, was only found in the influent of the WWTP. The highest MP mass contents were found in the combined sewer, so MP can become a source of pollution during heavy rain events when the capacity limits of the effluent are reached, and the polluted effluent is released uncontrolled into the environment. Based on the studies, MP retention from the WWTP could be estimated to be approximately 96%. Few trends in polymer type or mass contents were detected within the different fractions of the samples or when comparing samples to each other.
More Papers Like This
Point-source tracking of microplastics in sewerage systems. Finding the culprit
AI summary Read the abstract
Researchers traced microplastic pollution back to specific sources within sewerage systems by sampling wastewater from hospitals, food processing facilities, and domestic drains. They found that each source had a distinct microplastic fingerprint in terms of polymer type, size, and concentration. The study demonstrates that targeted source tracking within sewer networks could help identify and reduce the largest contributors of microplastic pollution before it reaches treatment plants.
Microplastics in drinking water: quantitative analysis of microplastics from source to tap by pyrolysis–gas chromatography-mass spectrometry
AI summary Read the abstract
Researchers used pyrolysis–GC-MS to quantify microplastics by mass concentration at each stage of Amsterdam's drinking water supply—from raw surface water through two treatment plants to household tap water—providing rare mass-based data on MP fate during treatment.
Microplastic occurrence in urban sewage systems: Identification of sources for pathways into the environment
AI summary Read the abstract
Researchers investigated microplastic occurrence in urban sewage systems in Germany, mapping sources and pathways by which microplastic particles enter wastewater infrastructure from textiles, road runoff, and industrial discharges. They found microplastics in all sampled systems and identified lack of standardized methods as a major barrier to generating comparable data across studies. The study supports development of targeted urban microplastic source reduction strategies.
The urban microplastic footprint: investigating the distribution and transport
AI summary Read the abstract
Researchers investigated the distribution and transport of microplastics within an urban environment, mapping the 'urban microplastic footprint' to understand how city infrastructure and land use patterns drive the spatial distribution and downstream export of plastic particles to receiving water bodies.
Detection of microplastic traces in four different types of municipal wastewater treatment plants through FT-IR and TED-GC-MS
AI summary Read the abstract
Researchers detected microplastic traces in four different types of municipal wastewater treatment plants using FT-IR and TED-GC-MS, finding that while treatment processes removed most microplastics, some were still released into receiving water bodies.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.