0
Article ? AI-assigned paper type based on the abstract. Classification may not be perfect — flag errors using the feedback button. Tier 2 ? Original research — experimental, observational, or case-control study. Direct primary evidence. Environmental Sources Marine & Wildlife Policy & Risk Sign in to save

Microplastic contamination in water and sediments of Mahanadi River, India: An assessment of ecological risk along rural-urban area

Journal of Environmental Management 2023 54 citations ? Citation count from OpenAlex, updated daily. May differ slightly from the publisher's own count. Score: 50 ? 0–100 AI score estimating relevance to the microplastics field. Papers below 30 are filtered from public browse.
Kalpana Patidar, Balram Ambade Kalpana Patidar, Kalpana Patidar, Kalpana Patidar, Kalpana Patidar, Kalpana Patidar, Kalpana Patidar, Kalpana Patidar, Balram Ambade Balram Ambade Balram Ambade Balram Ambade Balram Ambade Balram Ambade Santosh Kumar Verma, Faruq Mohammad, Balram Ambade Faruq Mohammad, Balram Ambade Balram Ambade Balram Ambade Balram Ambade

Summary

Researchers assessed microplastic contamination in the water and sediments of the Mahanadi River estuary in India during pre-monsoon and monsoon seasons. The study found microplastics across all sampling sites, with fibers as the most common shape and polyester as the dominant polymer type, and risk indices indicating very high pollution hazard levels. Evidence indicates that urban runoff and domestic waste are major contributors to microplastic pollution in this coastal river system.

Study Type Environmental

Worldwide, environmental concerns about MPs pollution have increased. Microplastic contamination that pollutes the ocean is mostly caused by terrestrial transfer from close proximity locations. A study of MPs pollution near coastal locations becomes necessary to address the MPs transit, fate, and mitigation. In the current study MPs pollution in the surface water and sediment of the Mahanadi River estuary was assessed during Pre-MS and MS. The size, shape, and colour of the MPs were determined using a stereomicroscope, and the MPs polymer composition was identified by Attenuated Total Reflection-Fourier Transform Infrared (ATR-FTIR) spectroscopy. The mean concentration of MPs that were potentially discovered in water was 16.6 ± 5.2 and sediments 197.3 ± 5.4 during Pre-MS. In the MS observed mean abundance of MPs was 15.1 ± 5.4 in water and 164.6 ± 76.9 in sediments. The highest abundant size was smaller than 1 mm; the most prevalent shape were fibers followed by film and fragments; black and white was a prominent colour in water and sediments respectively. Polyesters (PEs), polyethylene (PE), polyvinyl chloride (PVC), polypropylene (PP), polyamide (PA), Polystyrene (PS), and Polycarbonates (PC) were found in the analysis of the chemical composition of MPs in water and sediments samples. The calculated PLI value shows pollution load at category I, with polymer hazard levels at categories III, IV, and V, indicating very high risk. The current research results show that river inflows and fishing-related actions are probably the main causes of MPs pollution.

Sign in to start a discussion.

Share this paper