0
Article ? AI-assigned paper type based on the abstract. Classification may not be perfect — flag errors using the feedback button. Tier 2 ? Original research — experimental, observational, or case-control study. Direct primary evidence. Detection Methods Environmental Sources Policy & Risk Sign in to save

Plastic and rubber polymers in urban PM10 by pyrolysis–gas chromatography–mass spectrometry

Analytical and Bioanalytical Chemistry 2025 2 citations ? Citation count from OpenAlex, updated daily. May differ slightly from the publisher's own count.
Tatu Martinmäki, Sanna Saarikoski, Hilkka Timonen, Jarkko V. Niemi, Markus Sillanpää

Summary

Researchers developed a method to measure microplastic and rubber particles in urban air pollution (PM10) using pyrolysis and mass spectrometry. They found that plastics including polyethylene, polypropylene, and tire wear particles accounted for 1-3% of total airborne particulate matter sampled at a busy street in Helsinki. The findings confirm that people in urban areas are continuously inhaling microplastic and rubber particles from traffic and other sources.

Microplastics, including tyre and road wear particles, have been detected in every environmental compartment in both urban and remote areas. However, their contribution to atmospheric particulate matter is still sparsely explored. These airborne micro- and nanosized particles are continuously inhaled and pose risks to the environment and public health. The objectives of this study were to develop and validate a thermoanalytical method for the quantification of microplastics in urban particulate matter. Aerosol particles smaller than 10 µm in aerodynamic diameter (PM) were sampled at the kerbside in Helsinki, Finland, during spring 2024. The samples were pretreated by homogenization and thermal desorption prior to chemical analysis by micro-furnace pyrolysis-gas chromatography-mass spectrometry. The developed method was validated in terms of selectivity, limits of quantification, linear range, trueness, precision, and measurement uncertainty. Instrument quantification levels were 8-270 ng. Expanded measurement uncertainties were 25-30% and 50-70% for the studied tyre wear rubbers and thermoplastics, respectively. Polyethylene, polyethylene terephthalate, polypropylene, polystyrene, and tyre and road wear particles were detected in urban PM samples, and their sum accounts for 1-3% of total PM. These results represent the level of airborne microplastic particles to which people can be exposed in urban environments.

Share this paper