We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Evaluation of the Munich Plastic Sediment Separator efficiency in extraction of microplastics from natural marine bottom sediments
AI summary Read the abstract
The Munich Plastic Sediment Separator was tested on unprepared natural marine sediment samples and found to efficiently extract microplastics without prior cleaning. Validating low-cost, practical extraction tools is important for standardizing microplastic monitoring in marine sediments.
Abstract The Munich Plastic Sediment Separator (MPSS), proposed by Imhof et al. ( ), showed its high efficiency in extracting microplastics (MPs) from natural sediment samples preliminarily cleaned and then enriched by MPs in laboratory. We tested the efficiency of the MPSS, assembled at the Atlantic Branch of P.P.Shirshov Institute of Oceanology (Kaliningrad), using unprepared natural bottom deposits of different types collected in the Baltic Sea. The tests that were performed included spikes of sediments with artificial reference particles (ARPs) and the sediment samples analyses with two separate methods of extraction and determination of MPs content in residuals of MPSS. While the ARP extraction efficiency from natural sediments by the MPSS was really high (97.1% ± 2.6%; p = 0.05; n = 14; confidence interval, t ‐distribution), the extraction efficiency of marine MPs was considerably lower (13–39%) than that obtained with a modification of the method previously published by NOAA. The remaining marine MPs were found in the spoil dump and in the bulk solution fractions of the separator, indicating that MPs were not perfectly cleaned from sediment particles, probably, due to presence of organic matter. It is concluded that the MPSS application for quantitative MPs analysis requires further testing and elaboration of standardized extraction procedures.
More Papers Like This
Comparison of microplastic isolation and extraction procedures from marine sediments
AI summary Read the abstract
Researchers compared five methods for extracting microplastics (40-710 μm) from marine sediments by spiking known MP quantities into sediment matrices and measuring percent recovery across extraction approaches. Results showed that sediment matrix composition, MP properties including size and polymer type, and extraction method all significantly influenced recovery efficiency, underscoring the need for standardized extraction protocols to enable cross-study comparisons.
Microplastic extraction from sediments established? – A critical evaluation from a trace recovery experiment with a custom-made density separator
AI summary Read the abstract
Scientists evaluated the accuracy of a custom density separator for extracting small microplastic particles from sediment, finding variable recovery rates across different polymer types. Standardized and validated extraction methods are essential for accurate measurements of microplastic contamination in sediment environments.
Comparison of pre-treatment methods and heavy density liquids to optimize microplastic extraction from natural marine sediments
AI summary Read the abstract
Researchers compared multiple pre-treatment methods and density separation liquids for extracting microplastics from marine sediments, identifying optimised protocols that improved recovery rates and reduced contamination, supporting the development of more standardised monitoring approaches.
A small-scale, portable method for extracting microplastics from marine sediments
AI summary Read the abstract
Researchers developed a portable, low-cost device for extracting microplastics from marine sediments using density flotation with zinc chloride solution. The Sediment-Microplastic Isolation unit achieved an average extraction efficiency of nearly 96% across different sediment types in a single step. This tool makes it easier for researchers to accurately measure microplastic contamination in seafloor sediments during field work.
Extraction of microplastics from sediment matrices: Experimental comparative analysis
AI summary Read the abstract
Extraction efficiencies of four methods for separating microplastics from sediment matrices were experimentally compared using spiked samples, finding that density separation with saturated NaCl was adequate for most polymer types but underperformed for high-density polymers, and that no single method achieved complete recovery across all particle sizes and shapes.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.