0
Article ? AI-assigned paper type based on the abstract. Classification may not be perfect — flag errors using the feedback button. Tier 2 ? Original research — experimental, observational, or case-control study. Direct primary evidence. Environmental Sources Marine & Wildlife Sign in to save

Variation in polymer types and abundance of microplastics from two rivers and beaches in Adelaide, South Australia

Marine Pollution Bulletin 2021 49 citations ? Citation count from OpenAlex, updated daily. May differ slightly from the publisher's own count. Score: 40 ? 0–100 AI score estimating relevance to the microplastics field. Papers below 30 are filtered from public browse.
A. C. Hayes, K. Paul Kirkbride, Sophie C. Leterme

Summary

Researchers found significantly higher microplastic abundance and polymer diversity in sediments from the urbanized Patawalonga creek compared to less urbanized sites near Adelaide, Australia, with most detected microplastics derived from recyclable products, indicating inadequate recycling as a key pollution driver.

Study Type Environmental

Microplastics are a major source of marine pollution and comprise of many recyclable polymers. For this study, we investigated the prevalence of microplastic polymers in an urban and non-urban setting and determined what type of plastic polymers was most common in these areas. This was conducted by extracting sediment and sand samples from 2 rivers and beaches in Adelaide, South Australia. The microplastics were extracted using density separation and were identified using Fourier-transform infrared spectroscopy. We found a significantly higher abundance of microplastics and variety of polymers in the sediment of the Patawalonga creek, compared to the less urbanised environment. Most of the microplastics found in the study were from recyclable products which highlight the lack of recycling practices undertaken by the inhabitants of that area.

Sign in to start a discussion.

More Papers Like This

Article Tier 2

Quantifying environmental emissions of microplastics from urban rivers in Melbourne, Australia

Researchers quantified microplastic pollution in four Melbourne rivers flowing into Port Phillip Bay, finding an average of 9 microplastics per liter with polyamide and polypropylene among the most common polymers detected across all sampling sites.

Article Tier 2

Abundance, distribution patterns, and identification of microplastics in Brisbane River sediments, Australia

Microplastics were found throughout Brisbane River sediments in Australia, with concentrations, shapes, and polymer types varying with proximity to urban areas and river flow patterns. The study provides baseline contamination data for one of Australia's major subtropical rivers and identifies priority areas for pollution management.

Article Tier 2

Catchment characteristics and land-use influence on microplastics distribution in freshwater sediments

A study of three urban creeks in Brisbane, Australia found microplastic levels up to 4,400 particles per kilogram of sediment, with concentrations highest at downstream and estuary sites in urbanized zones. Polyethylene, polypropylene, and acrylic (PMMA) were the dominant plastic types, pointing to consumer products and stormwater runoff as key local pollution sources.

Article Tier 2

Microplastics in urban freshwater streams in Adelaide, Australia: A source of plastic pollution in the Gulf St Vincent

The first investigation of microplastic contamination in urban freshwater streams in Adelaide, Australia found MPs present in all sampled streams, identifying them as a likely conduit for plastic pollution entering the Gulf St Vincent. Fiber shapes were dominant, suggesting textile laundering as a major local source.

Article Tier 2

Microplastic emission characteristics of stormwater runoff in an urban area: Intra-event variability and influencing factors

Researchers investigated microplastic emission characteristics in urban stormwater runoff from industrial and residential catchments. Microplastics were detected in concentrations of 54 to 639 particles per liter, with polypropylene and polyethylene being the dominant polymers and fragments the most common shape, and concentrations were higher after longer dry periods.

Share this paper