We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Highly selective electrochemical impedance spectroscopy-based graphene electrode for rapid detection of microplastics
Summary
A graphene electrode derived from petroleum waste was developed and applied as an electrochemical impedance spectroscopy sensor for highly selective detection of microplastics in aquatic samples. The approach offers a sensitive and selective alternative to optical methods for environmental microplastic monitoring.
The widespread occurrence of microplastics (MPs) in aquatic ecosystems that caused environmental pollution has attracted worldwide attention. Herein, graphene electrode was initially derived from petroleum waste. Then the electrochemical responses of the electrode were evaluated using electrochemical impedance spectroscopy (EIS) toward polystyrene (PS) under various optimum conditions. For the quantitative measurement of PS concentration, principal component analysis (PCA) score images displayed that the data points offered the best discrimination of the classes, and singular value decomposition (SVD) showed that a good linearity was achieved between Z"u(1) and lgC in the concentration range of 0.01-25 mg L. Especially for PS with particle size of 1 μm, the highest correlation coefficient (R = 0.9914) was obtained. The sensor ability to determine the polystyrene concentration in real samples was evaluated with the recovery of 98.4-113.3 % and reliable reproducibility (RSD < 9.72 %). For the quantitative measurement of the particle size of PS, SVD images exhibited that a linearity was obtained between Z'u(1)and lgD in the particle size range of 0.08-20 μm. A good linearity with R = 0.9877 was obtained when the concentration was 1 mg L. The recovery was in the range of 100.8-118.0 % with the RSD < 6.38 %. Therefore, a novel method is established for the rapid detection of PS MPs.
Sign in to start a discussion.
More Papers Like This
Electrical impedance spectroscopy based strategy for detecting and differentiating microplastics in water
Researchers developed a submersible electrical impedance spectroscopy approach capable of detecting and differentiating microplastics directly in biologically active aquatic environments, overcoming the labor-intensive preprocessing requirements of conventional FTIR and Raman methods.
Electrochemical Detection of Microplastics in Water Using Ultramicroelectrodes
Researchers developed a new electrochemical method for detecting microplastics in water using ultramicroelectrodes. The technique works by monitoring changes in electrical current when microplastic particles collide with and adsorb onto the electrode surface, and the size distributions obtained closely matched independent measurements, demonstrating its potential as a practical detection tool.
Protocol for low-cost quantification of microplastics through electrochemical impedance spectroscopy from aqueous matrices
Most methods for detecting microplastics in water require expensive equipment or time-consuming laboratory steps. This study presents a simple protocol using electrochemical impedance spectroscopy (EIS) — measuring how microplastics change the electrical resistance of a solution — to rapidly and cheaply quantify plastic particles in water samples. Validated against conventional optical methods, the approach could make routine microplastic monitoring more affordable and accessible, particularly for lower-resource settings or high-throughput screening applications.
Recent advances in the detection of microplastics in the aqueous environment by electrochemical sensors: A review
This review surveys recent advances in using electrochemical sensors to detect microplastics in water environments. Researchers evaluated sensors made from carbon materials, metals, biomass materials, and microfluidic chips, comparing their detection capabilities and practical advantages like low cost and high sensitivity. The study highlights electrochemical sensing as a promising approach for real-time, on-site monitoring of microplastic contamination in waterways.
Graphene and gold nanoparticle-based bionanocomposite for the voltammetric determination of bisphenol A in (micro)plastics
Researchers developed a highly sensitive electrochemical sensor using graphene and gold nanoparticles to detect bisphenol A leaching from plastics and microplastics in water. The sensor achieved very low detection limits and worked reliably in real water samples. This tool could help environmental scientists and regulators better monitor harmful chemical release from plastic pollution in freshwater and marine environments.