We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Zeolitic Imidazolate/Fe3O4 Nanocomposite for Removal of Polystyrene and 4-tert-butylphenol via Adsorption
AI summary Read the abstract
Researchers developed a zeolitic imidazolate/Fe3O4 nanocomposite and tested its simultaneous removal of polystyrene microplastics and the endocrine disruptor 4-tert-butylphenol via adsorption. Under optimized conditions — 1.5 mg/L nanocomposite, 30-minute contact time, and 1:1 zeolitic imidazolate to Fe3O4 ratio — removal efficiencies of 99% and 98% were achieved for polystyrene and 4-tert-butylphenol respectively.
Simultaneous removal of microplastics and endocrine disruptors was performed with high yields using Zeolitic imidazolate/Fe3O4 nanocomposite. Polystyrene and 4-tert-butylphenol were used to indicate the microplastic and endocrine disruptors. Under optimal conditions for maximum yields, the matrix was as follows: 1.5 mg/l Zeolitic imidazolate/Fe3O4 nanocomposite, 30 min adsorption time at a Zeolitic imidazolate to Fe3O4 ratio of 1/1, and 6 mg/l individual polystyrene 4-tert-butylphenol concentrations. Under these conditions, 99% and 98% removals were detected for polystyrene and 4-tert-butylphenol, respectively via adsorption. An excellent reproducibility was found for Zeolitic imidazolate/Fe3O4 nanocomposite under steadystate operational conditions. The FESEM analyses showed that Zeolitic imidazolate/Fe3O4 nanocomposite diameter was around 30 nm at a Zeolitic imidazolate to Fe3O4 nanocomposite ratio of 1/1 while some larger dodecahedral particles size was ≤ 300 nm. N2 adsorption–desorption measurements exhibited the porosity of Zeolitic imidazolate/Fe3O4 nanocomposite and the decrease of size is attributed to the incorporation of a nonporous magnetic phase via the addition of Fe2+ to the nanocomposite. BET results showed a specific surface area with a BET isotherm of 5000 m2 /g, and a pore size of 30 nm for Zeolitic imidazolate/Fe3O4 nanocomposite. In the XRD spectra of Zeolitic imidazolate/Fe3O4 nanocomposite, the structure of nanocomposite was not changed by the addition of imidazolate and Fe3O4 nanocomposite. HRTEM analysis indicated some crystal agglomerations by doping of zeolitic imidazolate to Fe3O4. The reusability of the Zeolitic imidazolate/Fe3O4 nanocomposite was excellent even after 60 times utilization. The yields were 88% and 85% after 60 runs while the nanocomposite was reused 20 times during runs with yields as high as 97% and 98%.
More Papers Like This
PSS‐Functionalized Fe 3 O 4 /ZIF‐67 Nanocomposite: An Efficient Adsorbent for Rapid Removal of Microplastics From Wastewater
AI summary Read the abstract
Researchers developed a magnetic nanocomposite material for rapid removal of microplastics from wastewater using ultrasound-assisted adsorption. The material achieved equilibrium within 15 minutes with a maximum adsorption capacity of 2816 mg/g for polystyrene microplastics, and also demonstrated broad removal capabilities for other microplastic types, organic dyes, heavy metals, and antibiotics.
Removal of polystyrene nanoplastics from aqueous solutions by a novel magnetic zeolite adsorbent
AI summary Read the abstract
Researchers synthesized a magnetic zeolite adsorbent using co-precipitation and tested it for removal of polystyrene nanoplastics from water, achieving a maximum adsorption capacity of 34.2 milligrams per gram. Iron oxide functional groups on the zeolite surface drove nanoplastic capture via electrostatic attraction, complexation, and pi-pi conjugation, and the material could be magnetically separated for reuse.
Polystyrene microplastics removal from aqueous solutions by magnetic iron nanoparticles
AI summary Read the abstract
Researchers tested magnetic iron oxide (Fe₃O₄) nanoparticles for removing polystyrene microplastics from water, systematically optimizing concentration, dosage, contact time, and pH, and found effective microplastic removal through adsorption interactions that could be leveraged for environmental remediation.
Efficient Adsorption Removal of Tetrabromobisphenol A from Water by Using a Magnetic Composite Fe3O4/GO/ZIF-67
AI summary Read the abstract
Researchers synthesized a magnetic composite material (Fe3O4/GO/ZIF-67) and demonstrated its highly efficient adsorption of tetrabromobisphenol A (TBBPA), a widely used brominated flame retardant, achieving a removal capacity of 232 mg/g within 120 minutes. The adsorption mechanism was driven by hydrogen bonding and pi-pi stacking interactions, and the magnetic properties allow easy recovery of the adsorbent from water.
Removal of Polystyrene Microplastics from Aqueous Solution Using the Metal–Organic Framework Material of ZIF-67
AI summary Read the abstract
Researchers demonstrated that the metal-organic framework ZIF-67 can effectively adsorb polystyrene microplastics from aqueous solutions, achieving high removal efficiency and suggesting MOF materials as a promising approach for microplastic removal from wastewater.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.