We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Accumulation of microplastics in soil after long-term application of biosolids and atmospheric deposition
AI summary Read the abstract
Researchers measured microplastic levels in agricultural soils that had received biosolid fertilizer applications over 23 years and also tracked atmospheric deposition of microplastics over two years. They found that biosolid-amended soils had significantly more microplastics than control soils, with concentrations increasing with years of application. The study also revealed that airborne microplastic deposition, while smaller in volume, represents an additional and previously underappreciated source of plastic contamination in farmland.
Land-applied biosolids can be a considerable source of microplastics in soils. Previous studies reported microplastics accumulation in soils from biosolid application, however, little is known about the contribution of atmospherically deposited microplastics to agricultural soils. In this study, we quantified and characterized microplastics in soils that have been amended with biosolids over the past 23 years. We also collected atmospheric deposition samples to determine the amount and type of plastics added to soils through atmospheric input over a period of about 2 years. Soil samples were taken from a replicated field trial where biosolids have been applied at rates of 0, 4.8, 6.9, and 9.0 t/ha every second crop. The biosolids were anaerobically digested and dewatered, and were applied by spreading onto the soil surface. Soil and atmospheric samples were extracted for microplastics by Fenton's reaction to remove organic matter followed by flotation in a zinc chloride solution to separate plastic from soil particles. Samples were analyzed for microplastics by optical microscopy and Laser Direct Infrared Imaging Analysis (LDIR). The mean number of microplastics identified from biosolids samples was 12,000 particles/kg dry biosolids. The long-term applications of biosolids to the soil led to mean plastics concentrations of 383, 500, and 361 particles/kg dry soil in the 0-10 cm depth for low, medium, and high biosolids application rates, respectively. These plastic concentrations were not significantly different from each other, but significantly higher than those found in non biosolids-amended soil (117 particles/kg dry soil). The dominant plastic types by number found in biosolids were polyurethane, followed by polyethylene, and polyamide. The most abundant plastics in soil samples were polyurethane, polyethylene terephthalate, polyamide, and polyethylene. Atmospheric deposition contributed to 15 particles/kg dry soil per year and was mainly composed of polyamide fibers. This study shows that long-term application of biosolids led to an accumulation of microplastics in soil, but that atmospheric deposition also contributes a considerable input of microplastics.
More Papers Like This
Microplastic fate in a chronosequence of biosolid‐amended agricultural soil in Southern Ontario, Canada
AI summary Read the abstract
A field study in 2022 tracked the fate of microplastics in agricultural soils amended with municipal biosolids over a chronosequence of application histories, filling a gap in environmentally relevant field data. Biosolid-amended soils showed elevated microplastic concentrations, raising concerns about the circular use of these fertilizers.
Comparing the microplastic content in biosolid-amended and non-amended agricultural soils
AI summary Read the abstract
Researchers compared microplastic content in biosolid-amended agricultural soils versus non-amended control soils, examining eleven amended and nine non-amended sites to quantify the contribution of biosolid application to soil microplastic loads. The study found higher microplastic concentrations in biosolid-amended soils, confirming that biosolid application is a significant pathway for microplastic introduction into agricultural land.
Fate of microplastics applied to agricultural soils in biosolids
AI summary Read the abstract
Researchers studied the fate of microplastics added to soil through biosolid amendments, tracking where particles went over time through different soil layers and environmental conditions. They found that microplastics can persist in agricultural soils and gradually migrate through the soil profile, potentially reaching deeper layers and groundwater. The study identifies biosolid application as a route by which microplastics become incorporated into agricultural soils and may persist for years.
Biosolid amendments as drivers for microplastic pollution in soil: Measurements and insight from multiple analytical methods in an agricultural field study
AI summary Read the abstract
Farms sometimes spread "biosolids" (treated sewage sludge) on fields as fertilizer, and this study measured microplastic particles in soil that had received these applications over a decade compared to untreated farmland. Using detailed chemical testing, researchers confirmed that soil treated with sludge contained identifiable plastic contamination, supporting concerns that this common farming practice can be a source of microplastics building up in agricultural land. Since these plastics can end up in the crops we eat and potentially in our food and water supply, understanding where they come from is an important step toward reducing our overall exposure.
Transfer and transport of microplastics from biosolids to agricultural soils and the wider environment
AI summary Read the abstract
Researchers measured microplastic concentrations in biosolids from two suppliers and in agricultural soils before and after biosolid application in Ontario, Canada, finding that biosolid application contributed 8,700–14,000 microplastic particles per kilogram of dry soil to agricultural fields.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.