We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Development and validation of an analytical pyrolysis method for detection of airborne polystyrene nanoparticles
AI summary Read the abstract
Scientists developed and validated a new method using thermal analysis to detect airborne polystyrene nanoparticles, which are too small for most current detection techniques. The method can measure nanoplastics at the nanogram level, enabling researchers to quantify these tiny particles in air samples. This is important for human health research because airborne nanoplastics are likely widespread but have been difficult to measure, and understanding air concentrations is essential for assessing how much people inhale.
Microplastic is ubiquitous in the environment. Recently it was discovered that microplastic (MP, 1 μm-5 mm) contamination is present in the atmosphere where it can be transported over long distances and introduced to remote pristine environments. Sources, concentration levels, and transportation pathways of MP are still associated with large uncertainties. The abundance of atmospheric MP increases with decreasing particle size, suggesting that nanoplastics (NP, <1μm) could be of considerable atmospheric relevance. Only few analytical methods are available for detection of nanosized plastic particles. Thermoanalytical techniques are independent of particle size and are thus a powerful tool for MP and NP analysis. Here we develop a method for analysis of polystyrene on the nanogram scale using pyrolysis gas chromatography coupled to mass spectrometry. Pyrolysis was performed using a slow temperature ramp, and analytes were cryofocused prior to injection. The mass spectrometer was operated in selected ion monitoring (SIM) mode. A lower limit of detection of 1±1 ng and a lower limit of quantification of 2±2 ng were obtained (for the trimer peak). The method was validated with urban matrices of low (7 μg per sample) and high (53 μg per sample) aerosol mass loadings. The method performs well for low loadings, whereas high loadings seem to cause a matrix effect reducing the signal of polystyrene. This effect can be minimized by introducing a thermal desorption step prior to pyrolysis. The study provides a novel analysis method for qualitative and semi-quantitative analysis of PS on the nanogram scale in an aerosol matrix. Application of the method can be used to obtain concentration levels of polystyrene in atmospheric MP and NP. This is important in order to improve the understanding of the sources and sinks of MP and NP in the environment and thereby identify routes of exposure and uptake of this emerging contaminant.
More Papers Like This
Quantitation of Atmospheric Suspended Polystyrene Nanoplastics by Active Sampling Prior to Pyrolysis–Gas Chromatography–Mass Spectrometry
AI summary Read the abstract
Scientists developed a method to measure polystyrene nanoplastics suspended in outdoor air using active air sampling and a specialized chemical analysis technique. They detected nanoplastics at multiple locations, confirming that these ultra-small plastic particles are present in the air we breathe. Since nanoplastics are small enough to penetrate deep into the lungs and potentially enter the bloodstream, reliable measurement methods like this are critical for understanding airborne exposure risks.
A novel application of thermogravimetry-mass spectrometry for polystyrene quantification in the PM10 and PM2.5 fractions of airborne microplastics
AI summary Read the abstract
Researchers developed a thermogravimetry-mass spectrometry method to quantify airborne polystyrene microplastics and found that most airborne polystyrene exists in the lung-penetrating PM2.5 fraction, with agricultural practices identified as a likely source.
Size-Resolved Identification and Quantification of Micro/Nanoplastics in Indoor Air Using Pyrolysis Gas Chromatography–Ion Mobility Mass Spectrometry
AI summary Read the abstract
Scientists developed a new method to measure micro and nanoplastics in indoor air down to 56 nanometers in size, using advanced mass spectrometry techniques. They found significant concentrations of plastic particles in both a laboratory and a private home, with polystyrene being the most common type, and also detected flame retardant chemicals associated with plastic furniture foam. This study provides some of the first evidence that people are breathing in substantial amounts of nanoscale plastic particles indoors, where most people spend the majority of their time.
Quantifying the Chemical Composition and Real-Time Mass Loading of Nanoplastic Particles in the Atmosphere Using Aerosol Mass Spectrometry
AI summary Read the abstract
Scientists developed the first real-time method to measure nanoplastic particles in the air using a specialized instrument called an aerosol mass spectrometer. They detected polystyrene nanoplastics at an urban site in China at concentrations of around 47 nanograms per cubic meter, confirming that we are breathing in tiny plastic particles. This tool could help researchers better understand how much airborne nanoplastic pollution people are actually exposed to.
Thermal desorption and analysis of atmospheric nanoplastics via PTR-MS
AI summary Read the abstract
Scientists developed a new method to detect tiny plastic particles called nanoplastics in air and water by heating them up and analyzing the gases they release. This is important because nanoplastics are so small they can get into our bodies through the air we breathe and food we eat, but until now they've been very hard to measure. The new technique could help researchers better understand how much plastic pollution we're actually exposed to and its potential health effects.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.