We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Release Characteristics of Small-Sized Microplastics in Bottled Drinks Using Flow Cytometry Sorting and Nile Red Staining
AI summary Read the abstract
Researchers used flow cytometry combined with fluorescent dye staining to detect very small microplastics released from PET drinking bottles under different environmental conditions. They found that sunlight exposure and alkaline conditions significantly increased the release of particles in the 1-5 micrometer size range. The study suggests that outdoor use and storage conditions for bottled drinks can substantially influence microplastic contamination levels.
Small-sized microplastics (MPs) pose concerns about potential risks to both the environment and human health. However, research on MP pollution is hampered by limitations in the detection techniques. Also, few studies have provided insight into the release of small-sized MPs from disposable polyethylene terephthalate (PET)-bottled drinks for outdoor usage. Thus, PET bottles’ potential to release small MPs sized 1–100 μm outdoors was studied in relation to physical and chemical parameters (temperature, sunlight irradiation, and drink characteristics) using flow cytometry and Nile Red dye. The results showed that temperatures below 80 °C had little effect on the release of MPs from PET bottles. Sunlight irradiation and alkalinity were prone to promote the generation of MPs, mostly 1–5 μm in size. Moreover, the combined impact test implied that two pairings—acidity with temperature and alkalinity with sunlight—positively affected MP release, with maximum releases of 21,622 ± 2477 particles/L and 31,081 ± 7173 particles/L, respectively. Based on the rapid quantification of small-sized MPs using flow cytometry after Nile Red selection, the results hereby presented will assist researchers in reducing MP release and aid them in the evaluation of MPs’ contamination of aquatic environments.
More Papers Like This
Development of a low-cost and rapid detection method for micro- and nanoplastics in beverages and its application
AI summary Read the abstract
Scientists developed a fast, inexpensive method combining fluorescence microscopy and flow cytometry to count micro- and nanoplastics in beverages, achieving over 97% recovery and processing samples in about eight minutes. The study also found that longer storage, more frequent opening, and freeze-thaw cycling all release more plastic particles into drinks, raising direct human exposure concerns.
Photodegradation-driven microparticle release from commercial plastic water bottles
AI summary Read the abstract
Researchers exposed seventy PET plastic water bottles to sunlight for ten weeks and measured the microparticles released into the water as the plastic degraded. They found that microparticle concentrations built up to 14-20 micrograms per liter within the first 30 days before plateauing, and that thinner-walled bottles with higher crystallinity released fewer particles. The study demonstrates that sunlight-driven degradation of plastic bottles is a meaningful source of microplastics in bottled drinking water.
Microplastic release from PET-packaged beverages and acidic condiments: Effects of storage time and environmental conditions
AI summary Read the abstract
Researchers tested plastic (PET) bottles of drinks like lemon juice, vinegar, and soda over eight months, measuring tiny plastic particles released into the liquid. Particle levels rose over time and were higher with outdoor storage or heat (45°C), while cold storage (4°C) kept levels lowest, with acidic drinks and storage conditions both affecting results.
Quantification of microplastics by count, size and morphology in beverage containers using Nile Red and ImageJ
AI summary Read the abstract
Microplastics in beverage containers were quantified by count, size, and morphology to characterize a potential route of human exposure to these particles. The study found microplastics across beverage container types, providing controlled quantitative data on how many particles consumers may ingest through drinks.
A Comparative Study About the Amount of Microplastic in Polyethylene Terephtalate (pet) Drinking Water That Was Exposed and Not Exposed by Sun at Environmental Health Laboratory of Poltekkes Kemenkes Semarang at the Year 2020
AI summary Read the abstract
Researchers compared the amount of microplastics released from different brands and conditions of PET water bottles, finding that UV exposure and bottle age affect how many particles leach into the water. This study highlights bottled water as a direct route of microplastic ingestion for consumers.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.