We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Application of a Micro Free-Flow Electrophoresis 3D Printed Lab-on-a-Chip for Micro-Nanoparticles Analysis
Summary
Researchers developed a 3D-printed microfluidic chip using free-flow electrophoresis to separate and analyze micro- and nanoparticles in a low-cost, reproducible device. This type of miniaturized lab technology could improve environmental monitoring of nanoplastics and other fine particles in water samples.
The present work describes a novel microfluidic free-flow electrophoresis device developed by applying three-dimensional (3D) printing technology to rapid prototype a low-cost chip for micro- and nanoparticle collection and analysis. Accurate reproducibility of the device design and the integration of the inlet and outlet ports with the proper tube interconnection was achieved by the additive manufacturing process. Test prints were performed to compare the glossy and the matte type of surface finish. Analyzing the surface topography of the 3D printed device, we demonstrated how the best reproducibility was obtained with the glossy device showing a 5% accuracy. The performance of the device was demonstrated by a free-flow zone electrophoresis application on micro- and nanoparticles with different dimensions, charge surfaces and fluorescent dyes by applying different separation voltages up to 55 V. Dynamic light scattering (DLS) measurements and ultraviolet-visible spectroscopy (UV-Vis) analysis were performed on particles collected at the outlets. The percentage of particles observed at each outlet was determined in order to demonstrate the capability of the micro free-flow electrophoresis (µFFE) device to work properly in dependence of the applied electric field. In conclusion, we rapid prototyped a microfluidic device by 3D printing, which ensured micro- and nanoparticle deviation and concentration in a reduced operation volume and hence suitable for biomedical as well as pharmaceutical applications.
Sign in to start a discussion.
More Papers Like This
Design and Testing of 3D-Printed Microfluidic Devices for Microplastic Monitoring
Researchers designed and tested a stereolithography 3D-printed microfluidic device with impedance spectroscopy electrodes for detecting microplastic particles in drinking water, demonstrating a low-cost fabrication approach for continuous microplastic monitoring systems.
Assessment of microplastics using microfluidic approach
Researchers developed a microfluidic chip-based method using Nile red fluorescent staining to detect and count microplastic particles, offering a faster and less expensive alternative to conventional microscopy and spectroscopy approaches for environmental monitoring.
A Low-Cost Microfluidic Method for Microplastics Identification: Towards Continuous Recognition
Researchers developed a low-cost 3D-printed microfluidic device combining Nile Red staining with continuous-flow processing to enable rapid, affordable microplastic identification, demonstrating performance comparable to conventional staining methods while supporting field-deployable monitoring.
A microfluidic approach for label-free identification of small-sized microplastics in seawater
Researchers developed a microfluidic approach for label-free identification of small microplastics in seawater, using impedance-based detection to distinguish different polymer types without chemical labeling, enabling faster and more practical environmental monitoring.
Microfluidics and Chip Development
Researchers developed microfluidic lab-on-chip approaches for two applications: bacterial analysis and microplastic separation, using the principles of fluid dynamics at small scales to create controlled testing conditions within compact chip environments. The project demonstrated that microfluidic platforms can be adapted for environmental monitoring of microplastics, offering a miniaturised and potentially high-throughput detection alternative to conventional methods.