We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Static modelling of the material flows of micro- and nanoplastic particles caused by the use of vehicle tyres
Summary
Researchers modeled the flow of tyre wear particles in Austria, finding that about 6% of tyre rubber is released as wear particles into the environment each year, with emissions entering air, soil, and surface water. The study estimated that of the 21,200 tonnes released annually, about 6% are microscale particles and 0.3% are nanoscale, and concluded that reducing overall vehicle mileage would be the most effective way to cut these emissions.
The emissions of tyre wear particles (TWPs) into the environment are increasing and have negative impacts on the environment and human health. The aim of this study was therefore to establish a mass balance for vehicle tyres und TWP emissions in Austria using static material flow analysis, which enabled a quantification of mass flows of rubber including carbon black as the most mass-relevant tyre filler. Vehicle-specific and mileage-dependent emission factors were used to calculate the TWP emissions. The results for the year 2018 indicate that 80% of the tyre rubber remained in use, while 14% was re-treaded, recycled, incinerated or exported as end-of-life tyres and 6% was emitted as TWPs to air, soil or surface water. Of these 21,200 t/y released and dissipative lost TWPs, 6% were microscale, with a possible size between 0.1 and 10 μm, and 0.3% were nanoscale below 0.1 μm. The mass balance on the substance level shows that the TWPs contained 5,500 t/y of carbon black emitted in the form of airborne TWPs (6%) or entering in the soil or surface waters (47% each). Regarding air pollution from road vehicles, about 3,600 t/y were non-exhaust emissions, including tyre, brake and road-surface wear, which contributed to 9% of total dust emissions across Austria. Scenario analysis for 2050 with regard to e-mobility and the European Green Deal reveals that non-exhaust emissions can only be significantly reduced by a general reduction of the mileage or an environmentally friendly tyre design. This modelling approach provides a solid basis for decision makers in traffic planning as well as for chemical risk assessment. However, dynamic models with higher temporal and spatial resolution are needed to predict future mass flows of TWPs and their environmental fate, including their degradation products and possible accumulation effects.
Sign in to start a discussion.
More Papers Like This
Development of a parametrized and regionalized life cycle inventory model for tire and road wear particles
Researchers developed a detailed model for estimating tire and road wear particle emissions, a major but often overlooked source of microplastics from vehicle traffic. The model accounts for nine key factors including road texture, driving behavior, temperature, and tire type, and can generate estimates at both individual vehicle and national scales. The study found that road surface roughness, aggressive driving, and wet conditions are the biggest drivers of large particle emissions, while temperature and vehicle load most affect fine particle release.
Dynamic probabilistic material flow analysis of rubber release from tires into the environment
A dynamic material flow analysis model estimated the annual and cumulative release of rubber from vehicle tires into the environment via road wear, finding that tire rubber represents a substantial fraction of total microplastic pollution in terrestrial and aquatic systems. The study helps quantify this important but often overlooked microplastic source.
Modelled atmospheric concentration of tyre wear in an urban environment
Researchers modeled airborne concentrations of tire wear particles — tiny plastic-containing fragments released when vehicle tires rub against road surfaces — across Stockholm, finding that these microplastic particles are widespread in cities and make up 4–6% of total air particle pollution, with concentrations highest near busy highways and in narrow street canyons.
Tire Wear and Pollutants: An Overview of Research
This review provides an overview of tire road and wear particles as a major source of microplastic emissions, examining both experimental and mathematical approaches to measuring tire wear. The study notes that while tire wear particles are found in alarming amounts across various environments, they remain less studied than other microplastics, and calls for more accurate simulation models to predict tire wear emissions.
Tire Abrasion as a Major Source of Microplastics in the Environment
This study analyzed tire wear particles as a major source of microplastics in the environment, estimating that tire abrasion contributes a substantial fraction of total microplastic emissions globally and highlighting road runoff as a key delivery pathway to waterways.