0
Article Tier 2 Detection Methods Environmental Sources Sign in to save

Entrained Flow Gasification of Polypropylene Pyrolysis Oil

Molecules 2021 26 citations

AI summary Read the abstract

Researchers investigated entrained flow gasification of polypropylene pyrolysis oil as a circular feedstock alternative, finding that atomization and feeding challenges must be overcome but that the resulting syngas quality meets requirements for petrochemical production.

Polymers

Petrochemical products could be produced from circular feedstock, such as waste plastics. Most plants that utilize syngas in their production are today equipped with entrained flow gasifiers, as this type of gasifier generates the highest syngas quality. However, feeding of circular feedstocks to an entrained flow gasifier can be problematic. Therefore, in this work, a two-step process was studied, in which polypropylene was pre-treated by pyrolysis to produce a liquid intermediate that was easily fed to the gasifier. The products from both pyrolysis and gasification were thoroughly characterized. Moreover, the product yields from the individual steps, as well as from the entire process chain, are reported. It was estimated that the yields of CO and H2 from the two-step process were at least 0.95 and 0.06 kg per kg of polypropylene, respectively, assuming that the pyrolysis liquid and wax can be combined as feedstock to an entrained flow gasifier. On an energy basis, the energy content of CO and H2 in the produced syngas corresponded to approximately 40% of the energy content of the polypropylene raw material. This is, however, expected to be significantly improved on a larger scale where losses are proportionally smaller.

More Papers Like This

Article

Investigation and characterization of polypropylene plastic waste pyrolysis oil: Effect of temperature and fractional condensation

AI summary Read the abstract

Researchers investigated how pyrolysis temperature and fractional condensation affect the yield and quality of fuel oil derived from polypropylene plastic waste, seeking to optimize operating conditions for producing viable alternative fuels from a major waste stream.

Article

Municipal Plastic Waste Recycling through Pyrogasification

AI summary Read the abstract

Pyrogasification system converting 1,000 kg/h mixed municipal plastic waste into liquid fuel and gas without external heating.

Article Tier 2

Pyrolysis of Mixed Plastic Waste

AI summary Read the abstract

Researchers systematically characterized challenges in pyrolyzing mixed plastic waste — including oil contamination and incomplete conversion — and presented processing improvements that enhance oil yield and quality, positioning pyrolysis as a viable advanced recycling route for plastic streams that mechanical recycling cannot handle.

Article Tier 2

The Present and the Future of Polyethylene Pyrolysis

AI summary Read the abstract

This review examines the pyrolysis of polyethylene as a waste-to-energy strategy, discussing how key process parameters — temperature, catalyst type, and agitation — influence the yield and quality of liquid oils, fuel gases, and solid chars produced from non-biodegradable petroleum-based plastic waste.

Article Tier 2

Towards Sustainable Production of Chemicals and Fuels from the Fast Pyrolysis of Waste Polyolefin Plastics

AI summary Read the abstract

This thesis explores sustainable production of chemicals and fuels from the fast pyrolysis of plastic waste as a circular economy strategy, evaluating the technical and economic viability of converting plastic waste into valuable products. The work addresses the challenge of rising plastic waste generation and low recycling rates by examining thermochemical conversion pathways.

Research digests by email

When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.

Email me about

Share this paper