0
Article Tier 2 Detection Methods Food & Water Human Health Effects Sign in to save

Microbial Bioconversion of Polypropylene by Yarrowia Lipolytica: Enhancing Bioconversion and Lipogenesis through Optimization of Fermentation Parameters

AI summary Read the abstract

This study used the yeast Yarrowia lipolytica to biologically convert polypropylene into oleochemicals through a coupled pyrolysis and fermentation process. Optimizing fermentation parameters improved both bioconversion efficiency and lipid production from the plastic feedstock.

Polymers

Plastic waste can serve as a feedstock for microbial bioconversion using a chemical/biological hybrid strategy. In this work, a bioconversion process for polypropylene (PP) to produce value-added oleochemicals was reported. This bioconversion process coupled thermal depolymerization with fermentation by the oleaginous yeast Yarrowia lipolytica. PP pellets were depolymerized by pyrolysis, generating oil that consisted of mainly branched chain fatty alcohols and alkenes. The oil was mixed with biodegradable surfactants and nutrients and mechanically homogenized. The resulting medium, termed OP4, was used for fermentation by Y. lipolytica strain 78-003. Y. lipolytica assimilated > 80% of the substrate over 312 h, including 86% of the fatty alcohols. Y. lipolytica produced up to 540 mg L-1 lipids, compared with 216 mg L-1 during growth in surfactant-based control medium. C 18 compounds, including oleic acid, linoleic acid, and stearic acid, were the predominant products, followed by C 16 compounds palmitic and palmitoleic acid. Subsequently, an improved process was developed resulting in a PP-derived growth medium called OP5 that did not contain the emulsifier oleic acid and derived 81 percent of its carbon from PP. To improve on product yields during growth in OP5 medium, pH, inoculum density, C/N ratio, and osmolarity were optimized. This increased the product yield four-fold to 2.1 g L-1, and led to 46 percent cellular lipid content, the highest content reported to date for plastic-to-lipid microbial bioconversion. The maximum lipid yield occurred under conditions that balanced cell growth versus lipogenesis. Using postconsumer PP, the lipid yield was significantly lower (0.74 g L-1), likely due to toxic additives necessary for product stabilization. Overall, the work demonstrates the potential and the challenges associated with microbial bioconversion of plastics.

More Papers Like This

Article

Investigation and characterization of polypropylene plastic waste pyrolysis oil: Effect of temperature and fractional condensation

AI summary Read the abstract

Researchers investigated how pyrolysis temperature and fractional condensation affect the yield and quality of fuel oil derived from polypropylene plastic waste, seeking to optimize operating conditions for producing viable alternative fuels from a major waste stream.

Article Tier 2

Pyrolysis of Plastic Waste into The Fuel Oil

AI summary Read the abstract

This engineering paper describes the pyrolysis of plastic waste into fuel oil, evaluating process conditions and product yield. It is a waste-to-energy study relevant to plastic recycling but focused on industrial conversion rather than environmental microplastic contamination.

Article Tier 2

Pyrolysis of Mixed Plastic Waste

AI summary Read the abstract

Researchers systematically characterized challenges in pyrolyzing mixed plastic waste — including oil contamination and incomplete conversion — and presented processing improvements that enhance oil yield and quality, positioning pyrolysis as a viable advanced recycling route for plastic streams that mechanical recycling cannot handle.

Article Tier 2

Polyethylene degradation and assimilation by the marine yeast Rhodotorula mucilaginosa

AI summary Read the abstract

Researchers discovered that the marine yeast Rhodotorula mucilaginosa can degrade and assimilate polyethylene, reducing plastic mass, altering surface chemistry, and incorporating plastic-derived carbon into cellular lipids, suggesting a biological pathway for ocean plastic breakdown.

Article Tier 2

Bioprospecting indigenous bacteria from landfill leachate for enhanced polypropylene microplastics degradation

AI summary Read the abstract

Researchers isolated bacteria from landfill leachate to test their ability to degrade polypropylene microplastics. They identified a novel Staphylococcus haemolyticus strain that reduced polypropylene dry weight by over 25% in 30 days, with surface and chemical analysis confirming structural degradation through hydrolysis and oxidation.

Research digests by email

When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.

Email me about

Share this paper