We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Influence of sediment texture on HDPE microplastics recovery by density separation
Summary
This study examined how sediment texture — specifically grain size — affects the recovery of high-density polyethylene microplastics from sediment samples using density separation. Finer sediments retained more microplastics and reduced extraction efficiency. Matching extraction protocols to sediment type is essential for accurate microplastic quantification in environmental samples.
Microplastics (MPs) are an emerging environmental pollutant, threatening marine and terrestrial ecosystems. Because of their properties and their widely varying size (5mm-0.1 μm), it is still difficult to define a valid and efficient method for extracting MPs from solid matrices. Among the several methods proposed, density separation is the most practical and cost-effective one. Progress is still ongoing towards a deeper understanding of the advantages and limitations related to the application of density separation for MPs extraction, the recovery yields and the factors that may influence it. In this context, we introduce the following work, which provides an early-stage insight into how the sediment texture may influence the efficiency of this extraction method, and how parameters, such as sedimentation time and extraction cycles, can be modified to always achieve the best recovery. Our focus has been directed on evaluating the extraction efficiency of HDPE MPs by density separation using NaCl, from three types of sediment: sandy (SS), sandy loam (SLS) and sandy-clay loam (SCLS). We investigated the impact of sedimentation time (1, 6, 12, 24 h) and extraction cycles (3 cycles for each sedimentation time) on MPs recovery. Finally, we determined the minimum amount of MPs (MPs g/g sediment) below which it is not possible to quantify MPs with the method used. The results have shown that the recovery efficiency of MPs from sediment is structure dependent. The highest recoveries are reached after a settling time of 1 and 6 h. Furthermore, for samples with minimum clay content (SS), only one extraction cycle is needed, whereas two extraction cycles are required for SLS and SCLS. The outcomes about the detection limit (LOD) of the method, showed the existence of an interaction MPs-clay/sediment, which allowed us to understand how far this extraction method is suitable in field, thus defining the minimum grade of MPs pollution (MPs g/g sediment) below which this method is no longer capable to extract MPs from contaminated samples.
Sign in to start a discussion.
More Papers Like This
Microplastic extraction from sediments established? – A critical evaluation from a trace recovery experiment with a custom-made density separator
Scientists evaluated the accuracy of a custom density separator for extracting small microplastic particles from sediment, finding variable recovery rates across different polymer types. Standardized and validated extraction methods are essential for accurate measurements of microplastic contamination in sediment environments.
Extraction of microplastics from sediment matrices: Experimental comparative analysis
Extraction efficiencies of four methods for separating microplastics from sediment matrices were experimentally compared using spiked samples, finding that density separation with saturated NaCl was adequate for most polymer types but underperformed for high-density polymers, and that no single method achieved complete recovery across all particle sizes and shapes.
Not all microplastics are created equal. Quantifying efficacy bias and validation of density separation methods
Researchers evaluated and validated density separation methods for extracting microplastics from environmental matrices, quantifying efficacy bias across different polymer types with varying densities. They found that recovery rates differ substantially depending on polymer density relative to the separation solution, introducing systematic bias in microplastic concentration estimates across studies.
Validation of density separation for the rapid recovery of microplastics from sediment
Researchers validated a density separation method for rapidly recovering microplastics from sediment samples, confirming it as a reliable and efficient approach for routine environmental monitoring.
Comparison of Different Procedures for Separating Microplastics from Sediments
Researchers compared three different methodologies for separating dense microplastics from fine sediments, finding significant differences in recovery rates and identifying contamination risks during the separation procedures.