88 Microplastic References for Inhalation Studies

Abstract Microplastic research has been increasing due to the uncertainty of potential effects on the environment and human health. However, microplastic references are currently missing. Not only is there a lack of references there is also a lack of diversity in polymer type for references, especially in toxicological studies. In specific, inhalation studies must rely on microplastics that are respirable and/or inhalable (< 10 µm) to result in toxicological outcomes. Therefore, in this project, we focus on using solvent precipitation to produce microplastic references from TPU, PA-6, PET, and LDPE for microplastic inhalation toxicity studies. Particle size distribution of the dispersion is used to verify that the desired size range is achieved. To demonstrate that the produced microplastic references are representative from its original material, molecular and particle descriptors are characterized. Chemical composition, molecular weight, crystallinity, solidity, density, are among the descriptors tested for both the produced microplastic references and its corresponding commercial counterpart. Preliminary results have shown that quantities needed for in-vitro testing and particle size range desired is achieved with successful production of sub-100 nm constituent particle counts and all-respirable mass-based diameters. SEM images confirm the size distribution and show distribution of particle shapes. Chemical composition via spontaneous Raman Scattering illustrates clear polymer spectra signals from the microplastic dispersions. These microplastic reference materials are complemented by toxicology controls. In addition, the in-vitro screening uses both submersed and air-liquid interface cultures to expose cells. This study will thus provide information on microplastic material descriptors relevant for inhalation toxicity.