We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Occurrence and size distribution study of microplastics in household water from different cities in continental Spain and the Canary Islands
AI summary Read the abstract
Researchers sampled tap water from 24 locations across mainland Spain and the Canary Islands to measure microplastic contamination in household drinking water. They found an average of about 12.5 microplastic particles per cubic meter of tap water, with synthetic fibers being the most common type detected. The study provides one of the first standardized comparisons of drinking water microplastic levels across multiple cities within a single country.
The purpose of this study was to investigate the occurrence of microplastics (MPs) in drinking water in Spain by comparing tap water from different locations using common sampling and identification procedures. We sampled tap water from 24 points in 8 different locations from continental Spain and the Canary Islands by means of 25 μm opening size steel filters coupled to household connections. All particles were measured and spectroscopically characterized including not only MPs but also particles consisting of natural materials with evidence of industrial processing, such as dyed natural fibres, referred insofar as artificial particles (APs). The average concentration of MPs was 12.5 ± 4.9 MPs/m3 and that of anthropogenic particles 32.2 ± 12.5 APs/m3. The main synthetic polymers detected were polyamide, polyester, and polypropylene, with lower counts of other polymers including the biopolymer poly(lactic acid). Particle size and mass distributions were parameterized by means of power law distributions, which allowed performing estimations of the concentration of smaller particles provided the same scaling parameter of the power law applies. The calculated total mass concentration of the identified MPs was 45.5 ng/L. The observed size distribution of MPs allowed an estimation for the concentration of nanoplastics (< 1 µm) well below the ng/L range; higher concentrations are not consistent with scale invariant fractal fragmentation. Our findings showed that MPs in the drinking water sampled in this work do not represent a significant way of exposure to MPs and would probably pose a negligible risk for human health.
More Papers Like This
Polymers of micro- and nanoplastics in household tap water of Barcelona
AI summary Read the abstract
Researchers quantified micro- and nanoplastic polymers in the 0.7-20 micrometer size range in household tap water from the public drinking water network of Barcelona, Spain, using a novel workflow designed to capture smaller particle sizes than most previous studies. The cross-sectional study found microplastics present in drinking water at concentrations relevant to human daily exposure assessment.
Microplastic and nanoplastic concentration in tap water in the US
AI summary Read the abstract
Researchers analyzed microplastic and nanoplastic concentrations in tap water samples across the United States, detecting particles in the majority of samples and characterizing their size distribution, polymer type, and geographic variation.
Presence and Quantification of Microplastic in Urban Tap Water: A Pre-Screening in Brasilia, Brazil
AI summary Read the abstract
Researchers sampled tap water from Brasilia, Brazil and detected microplastics in all samples, with fibers as the dominant type and concentrations higher than many previous studies from other cities, highlighting the need for treatment infrastructure improvements and standardized monitoring.
Prevalence and implications of microplastics in potable water system: An update
AI summary Read the abstract
This review summarizes current knowledge on microplastic contamination in drinking water systems worldwide, covering sources, detection methods, and potential health implications. Researchers found that microplastics are present in both tap and bottled water, with fibers and fragments being the most common types detected. The study highlights the need for standardized testing methods and regulatory limits to protect public health from microplastic exposure through drinking water.
Occurrence and identification of microplastics in tap water from China
AI summary Read the abstract
Researchers analyzed 38 tap water samples from cities across China and found microplastics in all of them, with concentrations averaging around 440 particles per liter. Most particles were smaller than 50 micrometers, and the dominant types were polyethylene and polypropylene fragments. The findings highlight that drinking water treatment plants face a significant challenge in addressing microplastic contamination in the water supply.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.