Transformation of polyester fibre microplastics by sulfate based advanced oxidation processes

Advanced oxidation processes (AOPs) are a potential solution to microplastics (MPs) polluted wastewater but incomplete degradation can result in the formation of smaller fragments with altered surface chemistry. In this work, the impact of sulfate based oxidation on polyester MPs was investigated. Light, heat and ultrasound activation of persulfate resulted in varied degrees of mass loss and surface degradation, as probed by scanning electron microscopy (SEM), atomic force microscopy (AFM) and Fourier transform infrared spectroscopy (FTIR). Ultrasonic activation of persulfate resulted in significantly increased fragmentation and formation of smaller microplastic fibrils. Optimised UVC/peroxydisulfate (UVC/PDS) treatment (31.8 mW cm-2, 500 mg L-1) resulted in an 18.5% mass loss over 9 h with clear surface pitting and cracking. Extended treatment under these conditions for 24 h did not result in significantly increased mass loss but did cause an increased degree of surface degradation and increased roughness, indicating that incomplete mineralisation is likely in wastewater systems accompanied by MP transformation. The influence of a real laundry wastewater matrix was also studied and a decreased rate of mass loss was observed due to competing radical reactions with the organic content of the wastewater. Results advance understanding and therefore contribute to mitigating water pollution by MPs, since their physical and chemical transformation in real water treatment systems substantially affects the interaction with organic contaminants and changes the potential environmental risk of MPs.