We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
All black: a microplastic extraction combined with colour-based analysis allows identification and characterisation of tire wear particles (TWP) in soils
AI summary Read the abstract
This study developed a color-based extraction and analysis method to identify and characterize tire wear particles (TWP) -- estimated to make up over 90% of European microplastic emissions -- in soil samples. The method addresses the significant gap in reliable TWP concentration data needed to assess environmental health effects.
Abstract While tire wear particles (TWP) have been estimated to represent more than 90% of the total microplastic (MP) emitted in European countries and may have environmental health effects, only few data about TWP concentrations and characteristics are available today. The lack of data stems from the fact that no standardized, cost efficient or accessible extraction and identification method is available yet. We present a method allowing the extraction of TWP from soil, performing analysis with a conventional optical microscope and a machine learning approach to identify TWP in soil based on their colour. The lowest size of TWP which could be measured reliably with an acceptable recovery using our experimental set-up was 35 µm. Further improvements would be possible given more advanced technical infrastructure (higher optical magnification and image quality). Our method showed a mean recovery of 85% in the 35-2000 µm particle size range and no blank contamination. We tested for possible interference from charcoal (as another black soil component with similar properties) in the soils and found a reduction of the interference from charcoal by 92% during extraction. We applied our method to a highway adjacent soil at 1 m, 2 m, 5 m, and 10 m and detected TWP in all samples with a tendency to higher concentrations at 1 m and 2 m from the road compared to 10 m from the road. The observed TWP concentrations were in the same order of magnitude as what was previously reported in literature in highway adjacent soils. These results demonstrate the potential of the method to provide quantitative data on the occurrence and characteristics of TWP in the environment. The method can be easily implemented in many labs, and help to address our knowledge gap regarding TWP concentrations in soils.
More Papers Like This
All black: a microplastic extraction combined with colour-based analysis allows identification and characterisation of tire wear particles (TWP) in soils
AI summary Read the abstract
A color-based extraction method combined with aeration in saturated sodium chloride solution was validated as a reliable, rapid method to extract and identify black tire wear particles from soil samples using their distinctive color as a distinguishing feature.
[Black microplastics in the environment: Origin, transport and risk of tire wear particles].
AI summary Read the abstract
This review examines the origin, environmental transport, and health risks of tire wear particles (TWP) — black microplastics shed from vehicle tires — which disperse widely into air, soil, rivers, and food chains as vehicle ownership increases.
Methods for laboratory-generation and physico-chemical characterisation of tyre wear particles
AI summary Read the abstract
Researchers developed a lab method to generate tire wear particles using a friction machine and then identified a suite of chemical compounds that could serve as reliable markers for detecting these particles in environmental samples. Tire wear is one of the largest single sources of microplastic pollution globally, yet quantifying it in the environment has been hampered by the lack of agreed marker compounds. This work lays groundwork for standardized monitoring of tire particle pollution in soils and waterways.
Methodological approach to characterise tyre and road wear particles (TRWP) for environmental monitoring
AI summary Read the abstract
Researchers developed a new method for characterizing tire and road wear particles (TRWP) using infrared spectroscopy, addressing the challenge that black carbon in tires absorbs infrared light and makes standard FTIR analysis unreliable. The method allows better quantification and identification of TRWP in environmental samples, an important step for understanding a pollutant that is estimated to be the single largest source of synthetic polymer particles entering the environment. Accurate detection of TRWP is critical for assessing their environmental and health impacts.
Car and Truck Tire Wear Particles in Environmental Samples –A Comparison With “Traditional” Microplastic Mass Loads
AI summary Read the abstract
Researchers developed a method to identify and quantify tire wear particles in environmental samples alongside traditional microplastics using pyrolysis gas chromatography-mass spectrometry. They found that tire wear particles represent a substantial fraction of total microplastic mass in environmental samples and should be included in standard microplastic monitoring.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.