We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
A Vehicle-Based Experimental Approach to the Collection and Characterization of Tire and Road Wear Particles
Summary
Every time tires roll on the road, they shed tiny particles of rubber and mineral dust — some of the same "non-exhaust" pollution now raising concerns about microplastics in our air and environment. Researchers built a specialized vehicle system to capture and study these particles more accurately under controlled conditions, successfully recovering up to 81% of the worn tire material for close analysis. This matters because better collection methods are a key step toward understanding how much of this pollution we're actually breathing in or exposed to, even though this study focused on improving measurement tools rather than pinning down real-world health risks.
Tire and road wear particles (TRWPs) are major sources of non-exhaust traffic emissions. However, a limited understanding of their generation mechanisms and the lack of efficient collection methods under realistic driving conditions hinder accurate assessment. This study addresses these challenges by developing a vehicle-based methodology for the controlled recovery and characterization of TRWPs in the near-field region, rather than for direct quantification of real-world emissions. An autonomous electric vehicle was employed to ensure stable driving conditions and eliminate exhaust interference. Near-field distribution of TRWPs was visualized using a high-sensitivity optical scattering system. Based on this, a sealed tire enclosure with a high-power on-vehicle vacuum collection system was designed to enhance particle containment and recovery. Controlled circular driving tests were conducted on a dedicated outdoor test track under well-defined and repeatable conditions to enable system-level evaluation of TRWP generation and collection relative to measured tire wear. Particles were analyzed by thermogravimetric analysis, microscopy, scanning electron microscopy–energy-dispersive X-ray spectroscopy, and particle imaging. The results demonstrated stable, reproducible TRWP generation with ~60% collection efficiency relative to tire mass loss. These values are reported as system-dependent recovery indicators rather than precise emission estimates. Additional tests with an expanded recovery protocol indicated that collection efficiency can increase to ~81% (range: 73–91%), highlighting the influence of collection coverage. The collected TRWPs exhibited heterogeneous morphology, bimodal size distribution, and a mixed rubber–mineral composition in the 10–100 μm range. Spatial analysis revealed that TRWPs predominantly accumulated within a narrow zone around the driving lane. While the controlled experimental configuration enables reproducible particle generation and high-efficiency recovery, it represents a simplified driving scenario and may not fully capture the variability of real-world traffic conditions, including straight-line driving and transient maneuvers. Overall, this study demonstrates a technical framework for reproducible and comparative recovery of tire-associated particles under identical, well-defined conditions. The approach is intended to support controlled characterization studies while explicitly acknowledging limitations related to representativeness, particle origin attribution, and quantitative emission relevance, rather than to establish emission factors or mechanistic descriptions of TRWP generation.