We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Sustainable production of Low-Shrinkage fired clay bricks by utilizing waste plastic dust
AI summary Read the abstract
Researchers incorporated waste plastic dust into fired clay bricks at varying concentrations, finding that 7.5% plastic dust produced lightweight, low-shrinkage bricks with compressive strength and water absorption still within building standard limits, offering a practical method to reduce plastic burning in areas lacking formal waste management infrastructure.
Plastic waste is an immense challenge for waste management and sustainable development because it has been detrimental to aquatic and terrestrial life. The easiest and most common method to eliminate huge volumes of this waste is burning, which is harmful to environment. Plastic waste in bricks can reduce waste accumulation problems and partially replace natural resources (clay) with waste. This study mainly focused on utilizing waste plastic dust in fired clay bricks and investigating its effect on their physical and mechanical properties, such as compressive strength, water absorption, and density conforming to ASTMC67. The brick specimens were prepared for this purpose with varying percentages of plastic dust (0%, 2.5%, 5%, 7.5%, 10%, 12.5%, and 15%) by mass. By increasing the plastic dust percentage, the compressive strength was reduced, and water absorption increased. However, both remained within an acceptable range and passed the criteria of most building standards. The bricks produced were lightweight and exhibited considerably low shrinkage, leading to volume stability. The optimum percentage of plastic was found to be 7.5%, providing better results. It is corroborated that waste plastic dust can be utilized to manufacture relatively lightweight fired clay bricks with higher volume stability. This method can be adopted in areas where plastic is burnt in the open air to resolve plastic waste accumulation issues.
More Papers Like This
Exploiting recycled plastic waste as an alternative binder for materials used in the construction industry
AI summary Read the abstract
This South African study investigated the feasibility of producing eco-friendly plastic-sand bricks from HDPE plastic waste and river sand, testing six sand-to-plastic ratios with Kaolin Clay DSF additions. Adding 5% Kaolin Clay significantly improved compressive strength from 21.4 MPa to 52.76 MPa in the 75:25 ratio, demonstrating that recycled plastic waste can serve as a viable construction material with improved mechanical and environmental properties.
A Step towards Sustainable Concrete by Replacing Plastic Waste in Concrete: A Summary of its Mechanical Properties
AI summary Read the abstract
This study reviewed the use of plastic waste as aggregate or fiber in cement mortar and concrete, finding that plastic fibers enhanced mechanical performance while plastic coarse aggregates impaired concrete quality due to poor bonding. The review identifies research gaps and calls for further optimization to improve plastic-based concrete performance.
Investigation on properties of mortar with the use of simply shredded post-consumer plastic waste aggregate and molasses
AI summary Read the abstract
This study examines how incorporating shredded waste plastic as a partial aggregate replacement affects the mechanical and physical properties of cement mortar. Results provide insight into the feasibility of diverting plastic waste from landfills into construction materials, with tradeoffs typically observed in compressive strength and workability.
Investigating Mix Proportioning Effects on Compressive Strength of Concrete Containing Pelletized Plastic Aggregates for Environmental Benefit
AI summary Read the abstract
Incorporating pelletized waste plastic as a fine aggregate replacement in concrete reduced compressive and flexural strength by up to 45% at higher substitution levels, requiring strict limits on plastic content for structural applications. While this approach keeps plastic out of landfills and the environment, its mechanical limitations highlight the challenge of valorizing plastic waste at scale and reducing the volume that ultimately fragments into microplastics.
Performance assessment of industrial waste-based mortar under elevated temperatures
AI summary Read the abstract
Incorporating plastic waste as a sand substitute in cement mortar, alongside industrial by-products like micro silica and blast furnace slag, improved compressive strength and reduced mass while withstanding elevated temperatures up to 450°C. This demonstrates a circular economy pathway for diverting plastic waste from landfills and waterways into durable construction materials.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.