We can't find the internet
Attempting to reconnect
Something went wrong!
Hang in there while we get back on track
Upcycling of Expanded Polystyrene Waste-Impregnated PVP Using Wet-Phase Inversion for Effective Microalgae Harvesting
AI summary Read the abstract
Researchers upcycled expanded polystyrene foam packaging waste into filtration membranes by dissolving it and using wet-phase inversion with PVP, finding the resulting membranes effectively harvested Spirulina microalgae with reduced fouling compared to conventional membrane materials.
The aim of this study was to investigate the potential of upcycling Expanded Polystyrene (EPS) waste collected from food packaging into a membrane for microalgae harvesting, in which membrane filtration often challenges fouling and pore blocking. The target species is Spirulina platensis, with Chlorella vulgaris as a comparison agent. The membrane was fabricated from used Styrofoam, which typically ends up as single-use food packaging waste. In this study, PVP was used as an additive at varying concentrations, from 2 wt.% to 8 wt.%. The experimental results indicated that despite varying PVP concentrations, all EPS waste membranes exhibited near-complete recovery of Spirulina platensis biomass extraction. Despite the similar harvesting efficiency, EPS/PVP-8 exhibited the largest flux of 970.5 LMH/Bar, which is twice the value of the pristine EPS waste membrane. All membranes were hydrophilic; however, hydrophobicity increased with PVP concentration. SEM micrographs revealed that PVP enlarged the membrane surface pores and improved connectivity within the membrane's structure, ensuring efficient flow. The EPS waste membrane offers promising insights for sustainable materials and wastewater treatment. The upcycling of EPS waste into flat sheet membranes not only addresses the problem of Styrofoam waste accumulation but also paves the way to transform waste into valuable products.
More Papers Like This
Characteristics of Styrofoam Waste-based Membrane Through Vapor and Liquid-induced Phase Inversion Process
AI summary Read the abstract
Researchers prepared polymeric membranes from recycled Styrofoam waste using a phase-inversion technique with either immersion or evaporation solidification, finding that the solidification method significantly influenced hydrophobicity, pore configuration, porosity, and thermal stability of the resulting membranes.
Microplastic removal in aquatic systems using extracellular polymeric substances (EPS) of microalgae
AI summary Read the abstract
Researchers tested whether extracellular polymeric substances produced by microalgae could remove microplastics from water. Among four microalgae strains tested under stress conditions, Spirulina produced the most polymeric substances and formed the largest aggregates with microplastic particles. The study suggests that microalgae-based bioremediation could offer a sustainable, low-cost approach to reducing microplastic contamination in water sources.
Extracellular polymeric substances from Spirulina sp. for the bioremediation of fishing net–derived microplastics in seawater
AI summary Read the abstract
Researchers tested whether extracellular polymeric substances (EPS) secreted by the microalga Spirulina could remove polyethylene microplastics derived from fishing nets from seawater. The biological substances from Spirulina showed measurable ability to bind and aggregate the plastic particles, suggesting a natural bioremediation approach for marine microplastic pollution. This is relevant because discarded fishing nets are a major and persistent source of microplastics in the ocean.
The impact of polystyrene nanoplastics (PSNPs) on physiological and biochemical parameters of the microalgae Spirulina platensis
AI summary Read the abstract
Researchers exposed the microalgae Spirulina platensis to polystyrene nanoplastics at three concentrations over 20 days and found dose-dependent reductions in growth rate, dry weight, and photosynthetic pigments alongside increased oxidative stress markers, indicating nanoplastics impair algal physiology even at relatively low exposure levels.
Using Spirulina platensis as a natural biocoagulant for polystyrene removal from aqueous medium: performance, optimization, and modeling
AI summary Read the abstract
Researchers tested Spirulina platensis, a type of blue-green algae, as a natural coagulant for removing polystyrene microplastics from water. By optimizing conditions like pH, contact time, and dosage, they achieved significant removal of the plastic particles from aqueous solutions. The study suggests that natural biocoagulants could offer an eco-friendly approach to addressing microplastic contamination in water.
Research digests by email
When a large batch of papers lands in the Atlas, we read through it and send a short write-up of what stood out.